Table of Contents
Advertisement
A S S E M B LY I N S T R U C T I O N S
Step 6: Attach Top panel [A] to the unit as
shown in Fig. F with 4 KD screws.
Step 7: Tighten all KD SCREWS.
FIREPLACE INSERT
INSTALLATION
The fireplace insert can be installed after the
mantel has been fully assembled.
WARNING: Make sure the fireplace insert
controls are in the OFF position and the unit
is NOT plugged in.
Fig. E
Fig. F
Step 1: Carefully place the INSERT in the
unit opening. The front of INSERT should be
flush with the front of the mantel. Carefully
lift the INSERT into the mantel until the top
stopper is against the mantel.
Step 2: Attach top side of the insert with
3 Med bracket [T] and 3 Med KD screws
[V]. Attach 2 Mounting Brackets [U] at the
bottom side of insert with 2 Med KD screws.
See Fig. G.
Step 3: Move assembled unit to desired
location. Unit should not be positioned in
area exposed to direct sunlight.
WALL ANCHOR
SAFETY CABLE
The use of WALL ANCHOR SAFETY CABLE
is highly recommended in order to reduce
the risk of the fireplace being tipped over
accidentally. WARNING: This CABLE may
reduce possible risk of injury if the fireplace
is improperly handled, but is not a substi-
tute for proper adult supervision. Children
should not be left unattended near any
heater.
7
Fig. G
Advertisement
Table of Contents
