Maintenance - decorflame MM360-52GCN Manual

Step 16: Once the insert is in place, attach 2 L – mounting brackets [Vd] with 2 short
screws [Vc] onto base panel [D] (1 screw for each bracket). Attach 3 mounting
clips [Ve] with 3 medium screws [Vb] above the top side of insert. See Fig. P.
Step 17: Tighten all screws.
Step 18: Carefully move the assembled unit to the desired location. The fireplace mantel
should not be positioned in area exposed to direct sunlight.
OPERATION
After reading complete instructions, confirm all controls on fireplace are in the OFF
position. Plug the fireplace into a 15AMP/120Volt outlet. If the cord does not reach, you
may use an extension cord rated for a minimum of Nº 14 AWG, 1875 WATTS. Once the
fireplace insert has been properly connected to a grounded electrical outlet, it is ready
to operate.
OPERATION BY THE CONTROL PANEL
The controls are located at the right corner of the insert.
O/i: Press this button for main power function. The unit will beep and the indicator light
will be on. Pressing again will stop the main power function.
: To adjust the temperature to your individual requirements, turn the temperature
control dial to the right (clockwise) to increase the desired temperature and to the
left for lower temperature. This temperature control dial can only be used while the
O/I switch and 750W and 1500W switches are in the ON position.
Note: When the O/I switch is turned off, all other heater functions will stop even though
the switches may be in the on position.
Note: In order to shut down the heater safely, it is recommended to turn the temperature
control knob to lowest setting and allow the heater to cool down before press the O/I
switch to off position.
Fig. P Back
OPERATION BY THE REMOTE CONTROL
Plug in your electric fireplace and turn the O/I button to on position.
This means you have power and your remote is ready to operate
your electric fireplace.
: Press this button to turn ON the fireplace. The unit will
beep. Press again to turn off the fireplace and the fan will
continue to work for 5 seconds without heat.
The fireplace is preset to start with high heat (1500W) and the
highest flame intensity.
: Press this button once for flame effect. The unit will beep.
Press again to increase the flame intensity. There are 6
light intensities for your selection. The flame optics will go
higher under the sequence of 1, 2, 3, 4, 5 and 6. Pressing
the button again will stop the flame effect.
750w: Press this button for low heat level. The indicator light will be ON. The fireplace
heater will give low heat level. Pressing once again will stop the low heat level
function.
1500w: Press this button for high heat level. The unit will beep. The fireplace heater will
give high heat level. Press once again will stop the high heat level function.
NOtE: When the O/I switch is turned off, all other heater functions will stop even though
the switches may be in the on position.
REMOTE CONTROL BATTERY REPLACEMENT
Replace with a CR2025 battery and follow the diagram at the back of remote handset to
install the new battery.

MAINTENANCE

warNiNG: DiScONNEct pOwEr aND UNplUG tHE pOwEr cOrD BEFOrE attEMptiNG aNy
MaiNtENaNcE Or clEaNiNG tO rEDUcE tHE riSk OF FirE, ElEctric SHOck Or DaMaGE
tO pErSONS.
REPAIR SET
TOUCH-UP REPAIR PAINT
Paint directly on the mantel unit if necessary.
5
750W 1500W