Out Of Range; No Remote Output; Feature Not Available - Automate 5204A Owner's Manual

Out of Range

Each time a command is performed the Responder LE will expect a
command confirmation from the system. If a command confirmation
is not received the transmit LED flashes and a long fault tone plays as
an alert.

No Remote Output

Occasionally when a command is performed the remote may not
generate a command confirmation output or Out of Range output.
This indicates that the system received the command but it was an
incomplete command (e.g. Aux button pressed too short to activate
the trunk release) or it was an illegal message (e.g. the command
was corrupted due to local RF interference). These are temporary nor-
mal functions of the system and remote, perform the command again
within 10 seconds to return to normal operation.

Feature not Available

The Feature Not Available output (transmit LED flashing and long fault
tone) is a generic one which varies in cause and solution depending
upon the command used:
Command
Runtime Reset
Sensor Bypass
© 2012 Directed. All rights reserved.
Cause
Remote Start is Off
System is not armed
Reason/Solution
Only available when Remote Start is On
Only available when system is armed
23