Nuisance Prevention (Npc) - Automate 5204A Owner's Manual

the alarm is disarmed via the remote control, siren chirps, parking light
and control center LED flashes. The siren chirps 4 times (or 5 times if
NPC On*), the parking lights flash 3 times, and the control center LED
flashes in groups to indicate the last two zones that were triggered
(see Table of Zones). The report output will repeat for each disarm
operation until the ignition is turned on.

Nuisance Prevention (NPC)

* See
Zone # (led flashes)
1
2
3
4
5
6
Note: Warn away triggers are not reported.
Nuisance Prevention (NPC)
NPC monitors all alarm zones and, if any are triggered excessively,
bypasses them until corrected. If a point of entry (trunk, hood, door)
is left open following a forced entry, it is bypassed. It becomes active
again only after being closed.
Bypassed sensors automatically reset after one hour and after the
vehicle is driven. Disarming then re-arming the alarm does not reset
bypassed sensors.
16
for more details.
Table of Zones
Zone Name
Trunk
Shock Sensor
Door
Sensor 2
Ignition
Hood
© 2012 Directed. All rights reserved.