Full Trigger; Emergency Override; Trigger Zone Fault Report; Alarm Report - Automate 5204A Owner's Manual

Full Trigger

An alarm Full Trigger will sound the siren and flash the parking lights
for 30 seconds while sending a Full Trigger message to the remote
control. The LED's flash and siren tones play for 30 seconds

Emergency Override

The following procedure disarms the system when a programmed re-
mote is not available. Number of presses__________
Turn the ignition On.
1.
Press the control button on the Control Center the correct
2.
number of times (the default is 1 press).
3. After a few seconds the siren output ceases and the system
is disarmed.
Note
As a precaution, if programmed for Passive Arming or Auto
re-arming the system should be placed into Valet Mode until
a remote is available .

Trigger Zone Fault Report

When armed by remote command the system runs a status check of
the alarm trigger zones. Faulty zones (usually caused by dome light
delay or open trunk) are bypassed and reported via the control center
LED and remote, while all other trigger zones remain active and are
monitored to protect the vehicle. Should a faulty zone self correct
(dome light turns off) it becomes active and is then monitored normally.
The siren chirps once again a few seconds following the arming
chirps as an audible alert, the control center LED flashes in groups to
indicate the zone number.

Alarm Report

If the alarm was triggered while armed, it will be reported when
© 2012 Directed. All rights reserved. 15