Remote Start Time-Out Alert; Manual Transmission Start (Mts Mode); Turbo Timer Mode - Automate 5204A Owner's Manual

Remote Start Time-out Alert

During remote start a message is sent three minutes before and again
at one minute before the engine turns off. The Remote Start LED flashes
and several tones play as an alert to reset the runtime if desired.

Manual Transmission Start (MTS mode)

When installed into a manual transmission vehicle, the system requires
that the MTS mode is properly set when parking. If MTS mode is not
properly set or is defeated after being properly set the system will not
start the engine.
With the engine running, press the foot brake and set the park-
1.
ing brake. For Pit Stop or Turbo Timer mode (to leave the engine
running after arming), open the driver door.
Release the foot brake.
2.
Within 20 seconds of foot brake release, press any command
3.
button on the remote, after 20 seconds return to Step 2 (For Turbo
Timer Mode, press the optional dash mounted activation button).
4. The parking lights flash 5 times to confirm MTS mode enable and
the remote start activates the ignition outputs. The Remote Start
LED and On tones play to confirm.
Turn Off and remove the key from the ignition switch, the engine
5.
remains running.
Exit the vehicle, close all the doors and arm the system.
6.
7. The engine turns off and after a few seconds, the Remote Start
LED and Off tones play to confirm. If the door is opened in Step
3 then the engine continues to run.

Turbo Timer Mode

The system keeps the engine running for the Turbo Timer runtime and
can only be activated by an optional dash mounted activation button.
18 © 2012 Directed. All rights reserved.