Remote Start Faults - Automate 5204A Owner's Manual

With the engine running, set the parking brake (see previous
1.
information for manual transmission vehicles).
Press the optional dash mounted activation button.
2.
3. The parking lights turn on and the remote start activates the igni-
tion outputs. The Remote Start LED and On tones play to confirm.
Turn Off and remove the key from the ignition switch, the engine
4.
remains running.
Exit the vehicle, close all the doors and arm the system.
5.
6. The engine runs for the Turbo Mode runtime.
Note
Turbo Timer must be turned on and the optional dash mount-
ed push button must be installed by an authorized Directed
dealer.

Remote Start Faults

For user safety, the system must be properly configured or remote
start will not activate. The Remote Start Fault output (Remote Start LED
illuminates and long fault tone) may be caused by any of several
configuration issues. Refer to the following table for the command
type and parking light flashes that will identify the configuration issue
and solution.
Flashes * Possible Fault
5 Brake on
6 Hood open
7 After performing Remote Start
command - MTS not enabled
After performing Timer Start or
Smart Start command
8 Toggle Switch off
© 2012 Directed. All rights reserved.
Solution
Release foot brake
Close hood
Enable MTS mode
Check all Solutions
Turn switch on
19