Valet Mode; Power Save; Rapid Resume; Automatic Remote Updates - Automate 5204A Owner's Manual

Valet Mode

Valet mode can be entered and exited by using the vehicle key and
the control button. When entered, the alarm functions are defeated
while the convenience features still operate normally.
Arm and Disarm commands lock and unlock the doors. The Responder
LE emits the Arm in Valet and Disarm in Valet output as described for
Arm and Disarm in the Basic Commands section.
Use the following steps to manually enter and exit Valet Mode:
Turn the ignition switch On and then Off
1.
Immediately press and release the control button once
2.
3. The control center LED turns On when entering and Off when
exiting.

Power Save

To reduce power consumption the control center status LED modifies
its output if the vehicle is parked for an extended period. If Armed
the flashing is reduced after 24 hours. When Valet mode is On the
LED will turn off after one hour and will reset each time the ignition is
turned off.

Rapid Resume

If power is ever disconnected by a mechanic or thief, the system will
resume the state it was in at the time of disconnection, when power
is reconnected.

Automatic Remote Updates

The system sends a silent message to all remote controls after any
major action has occurred. When the remote receives this message it
updates the Arm status.
22 © 2012 Directed. All rights reserved.