Basic Commands (Direct Access); Arm; Disarm - Automate 5204A Owner's Manual

Basic Commands (Direct Access)

Arm

Press and release
The alarm arms, doors lock (if connected), and the siren chirps and
parking lights flash once. The Arm LED and beeps play to confirm.
If Valet mode* is On, the doors lock and the Arm LED, a fault tone
plays. Exit Valet mode to arm the alarm normally.
If a trigger zone fault is detected the siren chirps once again and the
remote will emit a Trigger Zone Fault Report**, the Arm LED, a fault
tone plays.
To Arm, Panic and activate Car Finder
Press and hold
The alarm Arms (or Locks in Valet) and, after 2 seconds, sounds
the siren and flashes the parking lights. The LED's flash and siren
tones play to confirm. Press the
put.

Disarm

Press and release
The alarm disarms, doors unlock (if connected), and the siren chirps
and parking lights flash twice. The Disarm LED and beeps play to
confirm. If Valet mode* is On, the doors unlock and the Disarm LED,
and fault tones play.
An Alarm Report** will replace the disarm output if the alarm was
triggered; the siren will chirp 4 or 5 times, and the Disarm LED, and
8
or button to stop the out-
© 2012 Directed. All rights reserved.