Runtime Reset; Remote Pairing - Automate 5204A Owner's Manual

Sensor Bypass off: The Parking lights flash 1 time. The Arm LED
and 1 beep play to confirm. Sensors are fully operational.
Note
System needs to be armed to perform Sensor Bypass.
Perform arm command any time to turn Sensor Bypass Off.

Runtime Reset

Press and release
If more time is needed while remote start is active, runtime reset will
reset the runtime counter to the pre-programmed setting. The Remote
start On tones play to confirm runtime reset.
Note Remote Start must be On to use this feature.
"Remote and System Operations" on page 21
* See
"Alarm Features" on page 14
** See

Remote Pairing

The following instruction will step you through the remote pairing op-
eration.
Open at least one of the vehicle's doors.
1.
Turn the key to the ON position.
2.
Within 5 seconds press and release 1 time the Control button on
3.
the Control Center.
Within 5 seconds, press and hold the Control button. The status
4.
LED will flash one time and the siren will chirp once to confirm the
system is ready for remote pairing.
Release the Control button.
5.
12
, then press and release
© 2012 Directed. All rights reserved.