Table of Contents
Advertisement
Introduction
This chapter explains how to deal with control panel messages,
remove jams, cancel jobs, and troubleshoot printer problems.
Responding to Status Messages
The following status messages may appear in the control panel
message window:
x ACTIVE
JOBS
ADJUST
xxxxx BIN
BACK PANEL
OPEN
BELT
CARTRIDGE
MIS-
INSTALLED
CANCELLING
JOB
CHECK
WASTE
TONER
CLOSE
MANUAL
FEED TRAY
x DEV LOW
T r o u b l e s h o o t i n g
EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500
The printer is on line, and one or more jobs are in
progress. The x is replaced by the number of jobs in the
queue.
A media cassette is either not installed or installed
incorrectly. The xxxxx indicates the cassette in
question. Either install or reinstall the indicated
cassette.
The back cover over the transfer unit is not fully closed.
Close the back cover.
The OPC belt cartridge is either not installed or
incorrectly installed. Either install a cartridge if one is
not present or reinstall the current one correctly. (See
c ha pte r 6, "Consumabl es a nd Preve nta tive
Maintenance," for information on replacing the OPC
belt cartridge.)
The Cancel key has been used to cancel the current job.
This message is displayed until the job is cancelled.
The waste toner pack is full and needs to be replaced
or is not installed properly. See "Replacing the Waste
Toner Pack" in chapter 6 for details.
The manual feed tray is open when a file is being sent
to print from another cassette. Close the manual feed
tray.
A developer cartridge is running low and needs to be
replaced. The x is replaced by the color of the developer
Chapter 9
9 - 1
Advertisement
Table of Contents
