Cleaning The Pre-Charger Unit - QMS 19 User Manual

13. Push the green end-handle down to lock the cartridge in place.
14. Close the manual feed tray.

Cleaning the Pre-Charger Unit

Clean the pre-charger unit whenever the print quality diminishes.
To clean this unit you need several cotton cloths and swabs, and
the wire cleaner located in the OPC belt tray (see figure 6.11 for
location).
To clean the pre-charger unit
1. Remove the waste toner pack. (See "Replacing the Waste
Toner Pack" in this chapter.) Then, set it aside on a surface
that toner residue can't hurt, such as on a piece of paper.
WARNING!
burn it. Also, avoid inhaling loose toner or getting it around
your eyes; it can cause respiratory problems and eye irritation.
ACHTUNG!
liches und leicht entzündliches Pulver; es darf deshalb niemals
mit offenem Feuer in Berührung kommen. Einatmen oder
Berührung mit Haut und Augen ist ebenfalls zu vermeiden, da
dies zu Beeinträchtigungen der Atemwege, Hautoder Augen-
reizungen führen könnte.
C o n s u m a b l e s a n d P r e v e n t a t i v e M a i n t e n a n c e
EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500
The toner is a highly combustible powder; never
Bei dem Toner handelt es sich um ein gefähr-
Chapter 6
6 - 3 1