Table of Contents
Advertisement
Min K Spool
Spool Timeout The number of seconds the interface waits for data from
End Job Mode This option enables or disables data stream sensing for
Baud Rate
Parity
Ignore Parity
Rcv Sw
Flow Ctl
P r i n t e r C o n f i g u r a t i o n
EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500
emulations, like LN03 Plus and CCITT, appear only if
installed. The factory default emulation is ESP.
The minimum amount of RAM (KB) dedicated to the
serial interface. Do not set this value greater than K
Mem for Spool. The default is 00015.
the host system before terminating a print job. The
minimum value is 00000 (no timeout), the maximum
value is 99999, and the factory default value is 00030.
end-of-document (EOD) terminator strings. These
sequences allow host computers to enforce print job
sequencing without considerations for interacting
timeouts. The values are none (printer recognizes only
t he PostSc ript ^D c omma nd), QMS EOD
(%%EndOfDocument ),
(<ESC>%-12345X). The factory default is none. See
"Cancelling and Ending Print Jobs" in chapter 5 for
more details.
The baud rate is a measure of the rate of transmission
(bits per second) from host to printer over the serial
channel. The baud rate options are 300, 600, 1200,
2400, 4800, 9600, 19200, and 38400. The factory
default is 9600. Host and printer baud rates must match.
Baud rates of 19200 and 38400 require either RTS or
CTS hardware flow control (Hdwe Flow Ctl). These
baud rates do not support XON/XOFF software flow
control (Rcv Sw Flow CTL).
Parity acts as a check bit to identify data transmission
errors. The options are none, mark, space, odd, or even.
The host or application parity setting must match the
printer's parity setting. The factory default is none.
Ignore parity options are off or on; the factory default
is off.
The software communication protocol used by the
printer to control communication from the host. The
options are XON/XOFF, robust XON/XOFF,
Chapter 4
and
HP
EOD
4 - 2 3
Advertisement
Table of Contents
