Table of Contents
Advertisement
Chapter 4
Gamma
Correction
Administration/Emulations/Lineprinter
Twelve configuration choices are available:
Font
Point Sz
100ths
Character
Maps
4 - 3 0
EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500
enhanced low, enhanced medium, and enhanced high.
St andard, the fact ory default se tting, is
PostScript-compatible dithering. Enhanced dithering
reduce s the ba ndi ng sometime s see n in
PostScript-compatible dithering, with enhanced high
producing the least banding. The factory-default
Standard setting should not be changed if you are using
the factory-default Enhanced halftone setting.
This option allows you to choose the amount of
gamma correction for the printer. Choices are
Gamma71
(0)
Gamma53
(1)
Gamma80
(2)
Gamma106 (3)
None
(4)
The default is None. The factory-default None set-
ting should not be changed if you are using the fac-
tory-default Enhanced halftone setting. Otherwise,
the gamma setting should correspond to the printer
default halftone chosen. (For example, when the 53
lpi x 45° halftone is selected, the Gamma53 gamma
setting should be selected.)
In this submenu, you can enter the name of a font (any
PostScript font on the printer) to be used for Lineprinter
jobs. The factory default is Courier. To see a list of
PostScript fonts available, print an advanced status
page from the front control panel (from the
Administration/Special Pages/Print Status submenu).
Sets the five-digit value used to specify the point size
of the font for the current print job. The range is from
00400 (4 points) to 25600 (256 points). The default is
00880 (8.8 points).
Specifies the type of character map to be used. The
choices are ASCII and EBCDIC. The default is ASCII.
P r i n t e r C o n f i g u r a t i o n
Advertisement
Table of Contents
