QMS 19 User Manual page 281

8. Gently pull the SIMM forward to a 90° angle until you feel it
fit into place (fig. 8.16) behind the clips on either side of the
connector. (You may need to use your fingers to open these
clips.) When seated, the SIMM stands upright, firmly in place.
CAUTION: If you cannot easily fit the SIMM into place, do not
force it. Reposition it, making sure that the bottom of the SIMM
is seated completely in the connector. If there's not enough room
between SIMMs to properly tilt and insert the new ones, first
remove all the SIMMs, install the new ones, then re-install the old
ones. Steps 4 and 5, above, explain how to remove SIMMs.
Fig. 8.16 Pull the SIMM Forward into Position
9. Follow the instructions in "Replacing the Controller Board"
(earlier in this chapter), being careful to follow the directions
for eliminating electrostatic buildup.
NOTE: You may want to print out an advanced status page
(Administration/Special Pages submenu) so you have a
P r i n t e r O p t i o n s
EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500
Chapter 8
9 0
8 - 2 5