Connect Power; Power Up; Figure 7- Connect The Power Cord - NTI RACKMUX-VS17-T Installation And Operation Manual

NTI RACKMUX-VS17-T RACKMOUNT LCD MONITOR WITH SUN KEYBOARD AND TRACKBALL MOUSE

Connect Power

Connect the IEC power cord to the power port as shown below.
NTI
1275 Danner Dr
Aurora, OH 44202
www.networktechinc.com
IEC Powercord

Power Up

Power up the RACKMUX-VS17-T and connected computer in this order.
1. Power On the RACKMUX-VS17-T
2. Power ON the attached CPU.
If a device is plugged into the USB port on the front of the RACKMUX, it can powered-ON at any time.
Note for DVI monitors only: If the message "NO SIGNAL" appears when the monitor is powered-ON, the monitor may be
set for a "PC" (VGA) input source. Press the Up Arrow button on the monitor to toggle the monitor input source setting
to "Digital" (DVI). (See also page 7)
REAR VIEW OF RACKMUX-VS17-T
NETWORK
TECHNOLOGIES
INCORPORATED
Tel:330-562-7070
Fax:330-562-1999

Figure 7- Connect the power cord

6