Uwatec Aladin PRIME Operating Manual page 40

VIII Settings
TEC Setting the safety stop duration
Duration of the safety stop
TEC Setting the maximum partial pressure of oxygen (ppO
ppO
2 max
Setting the time limit to reset the O
Time limit to reset O mix
2
to air
Selecting the units
TEC Selecting the water type
TEC Setting the backlight duration
40
1. Confirm that you wish to change the duration of the safety stop by pushing
. The duration starts to flash.
2. Change the duration in increments of 1 minute by pushing
.
3. Confirm the selected duration with
1. Confirm that you wish to change the ppO
rent value starts to flash.
2. Change the value in increments of 0.05 bar by pushing
3. Confirm the selected value with
% mix to air
2
1. Confirm that you wish to change the time limit of the reset by pushing
. The current setting starts to flash.
2. Change the time limit by pushing
(1 - 48 hrs. or no reset: "– – h")
3. Confirm the selected value with
1. Confirm that you wish to change the units by pushing
units are displayed (m / ft / °C / °F).
2. Push . "m" or "ft" starts to flash.
3. Switch with between "m" and "ft".
4. Confirm the selected unit with
5. Switch with between "°C" and "°F".
6. Confirm the selected unit with
1. Confirm that you wish to change the selected water type by pushing
"On" or "off" starts to flash.
"Salt on" indicates salt water, "salt off" indicates fresh water.
2. Switch with between "salt on" and "salt off".
Confirm the water type with
1. Confirm that you wish to change the duration of the backlight illumination by
pushing . The value starts to flash.
2. Change the duration with
3. Confirm it with
.
)
2 max
2 max
.
or
.
. "°C" or "°F" starts to flash.
.
.
. (2-12 sec)
.
by pushing . The cur-
or
.
. The selected
VIII UWATEC Aladin dive computers
® ®
or
.
.