Nitrogen Loading Bar Graph; Decompression Information - Uwatec Aladin PRIME Operating Manual

Table of Contents

Advertisement

4 Functions during the dive

4.9 Nitrogen loading bar graph

The nitrogen loading bar gives a graphical representation of how close to decompression you are. As you
absorb nitrogen during the dive, more and more segments of the bar will light up. Depending on your
depth, the segments can light up more or less rapidly.
1-3 segments
(green area):
you are safely wit-
hin the no-stop
range
** Depending on your profile, the no-stop time may drop below 3 minutes before the upper 5 segments
are lit. In this case, only those segments that are lit will flash.
If you have entered decompression, the 6
pression obligation to indicate that you are no longer in decompression.

4.10 Decompression information

NO STOP and the no-stop time (minutes) are displayed if no decompression stops are necessary.
DEPTH
DEPTH
DIVE TIME
DIVE
TIME
NO STOP
NO ST
OP
CNS O
%
2
No-stop time
Nitrogen loading bar
4 sec
DEPTH
DEPTH
DIVE
DIVE TIME
TIME
NO STOP
NO ST
OP
CNS O
%
2
No-stop time less
than 1 minute
Decompression values
Decompression obligation
DEPTH
DEPTH
DIVE TIME
DIVE
TIME
DECO
DECO
STOP
STOP
CNS O
%
2
Decompression
stop duration
Decompression
depth
24
4-5 segments (yellow area):
you are approaching decom-
pression. When the no-stop
time drops below 3 minutes
the 5 segments will start
flashing.**
segment will turn off as soon as you complete your last decom-
th
• No-stop display <99:> means remaining time of 99 minutes or
more.
• No-stop time is calculated on line and influenced by the current
water temperature
WARNING
WARNING
On entering the decompression phase, "NO STOP" disappears, the
bol appears and an attention beep goes off. The nitrogen loading bar stops flas-
hing and the 6th segment lights up (red area). The deepest decompression
stage in metres (feet) is displayed and the decompression stop duration of the
displayed stage appears in minutes. The display <7: 3m (10ft)> means that a
decompression stop of 7 minutes at a depth of 3m (10ft) has to be made.
When a decompression stop has been finished, the next higher decompression
stop is displayed. When all decompression stops have been made, the
symbol extinguishes, "NO STOP" and no-stop time reappear.
Deco stop depths deeper than 27m (90 ft) are displayed as <– – : – – >
If no-stop time drops below 3 minutes, an audible
attention signal is activated, the no-stop value and
the nitrogen loading bar begin to flash.
If no-stop time is less than 1 minute, the no-stop
display shows the flashing value "0".
In order to prevent a decompression dive, ascend
slowly until the no-stop time is 5 minutes or more.
Dives that require decompression stops are not
recommended.
6 segments (red area): you now
have mandatory decompression
obligation(s) which you must
observe before reaching the
surface.
DECO
DECO
sym-
STOP
STOP
DECO
DECO
III UWATEC
®
Aladin
®
dive computers
STOP
STOP

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Aladin tec

Table of Contents