Configuring The Serial Connectors - IBM Remote Supervisor Adapter II User Manual

1. Log in to the Remote Supervisor Adapter II where you want to set local events.
2. In the navigation pane, click Alerts and scroll down to the Monitored Local
3. Select the events that you want to store in the event log. The Remote
4. Scroll to the bottom of the page and click Save.

Configuring the serial connectors

Note: This feature is not available for the Remote Supervisor Adapter II SlimLine
To configure the serial connector, complete the following steps:
1. Log in to the Remote Supervisor Adapter II on which you want to configure the
30
Remote Supervisor Adapter II SlimLine and Remote Supervisor Adapter II: User's Guide
For more information, see Chapter 2, "Opening and using the Web interface," on
page 5.
Events area.
Supervisor Adapter II stores the notification only in the event log.
Local events are generated for events that are sent to IBM Director, if it is
installed, on the server where the ASM subsystem is located. These events are
not sent to remote alert recipients. If the Select all local events check box is
selected, an alert can be sent for any local event.
Table 5. Local events
Event
Event log 75% full
Voltage irregularity
Power off
Power supply failure
Event log full
Redundant power supply
failure
Tampering
DASD failure
Remote login
Temperature irregularity
Fan failure
PFA notification
Partition configuration
on some server models.
serial port. For more information, see Chapter 2, "Opening and using the Web
interface," on page 5.
Action
Generates a local notification if the event log reaches 75% of
capacity.
Generates a local notification if any of the monitored voltages
exceed their thresholds.
Generates a local notification if the server is turned off.
Generates a local notification if a power-supply failure is
detected.
Generates a local notification if the event log reaches its
capacity. At capacity, the oldest events are deleted.
Generates a local notification if the redundant power supply
fails.
v Generates a local notification if the server cover is removed.
This feature is available only on some servers.
v Generates a local notification if there are five login failures
(refresh 2 or later firmware only).
Generates a local notification if any hard disk drive failures are
detected.
Generates a local notification if a remote login occurs.
Generates a local notification if any of the monitored
temperatures exceed thresholds.
Generates a local notification if one or more cooling fans fail.
Generates a local notification if any of the hardware in the
server generates a PFA event.
Generates a local notification if any of the hardware in the
server generates a partition configuration event.