Portcfg Command - IBM Remote Supervisor Adapter II User Manual

Example
x345RSA> passwordcfg
Security Level: Legacy
x345RSA> passwordcfg -exp 365
ok
x345RSA> passwordcfg -nul yes
ok
x345RSA> passwordcfg -cnt 5
ok
x345RSA> passwordcfg
Security Level: Customize
-exp: 365
-cnt: 5
-nul: allowed

portcfg command

Note: The portcfg command is not available for the Remote Supervisor Adapter II
Syntax
portcfg com1 [options]
portcfg com2 [options]
options:
-serred serial_redirect_mode
-b baud_rate
-p parity
-s stop_bits
-climode cli_mode
-cliauth cli_auth
Description
Use the portcfg command to configure the serial port. Type portcfg com1 or
portcfg com2 to display the port configuration. To change the serial port
configuration, type the options, followed by the values. To change the serial port
configuration, you must have at least Adapter Networking and Security
Configuration authority.
The following table shows the arguments for the options.
Option Description
-exp Maximum password age [0 - 365] days. Set to 0 for no expiration.
-cnt Number of previous passwords that cannot be reused [0 - 5]
-nul Allows accounts with no password [yes | no]
-h Displays the command usage and options
SlimLine.
Option Description
-serred Serial redirect mode
-b Baud rate
-p Parity
-s Stop bits
Values
disabled, enabled
2400, 4800, 9600, 19200, 38400, 57600, 115200
none, odd, even, mark, space
1, 2
Chapter 6. Command-line interface
103