Power Command; Reset Command; Serial Redirect Command; Console Command - IBM Remote Supervisor Adapter II User Manual

power command

Syntax
power on
power off [-s]
power state
power cycle [-s]
Description
Use the power command to control the server power. To issue the power
commands, you must have power and restart access authority.

reset command

Syntax
reset [option]
option:
-s
Description
Use the reset command to restart the server. To use this command, you must have
power and restart access authority. The -s option shuts down the operating system
before restarting the server. When the -s option is specified, the Remote Supervisor
Adapter II software state is checked and if it is not active, the server is not
restarted. Instead, a message is displayed indicating that the Remote Supervisor
Adapter II software is not active.

Serial redirect command

There is one serial redirect command: console.

console command

Note: The console command is not available for the Remote Supervisor Adapter II
Syntax
console 1
console 2
power on turns on the server power.
power off turns off the server power. The -s option shuts down the operating
system before the server is turned off.
Note: The Remote Supervisor Adapter II software must be installed and running
for the -s option to function correctly.
power state displays the server power state (on or off) and the current state of
the server.
power cycle turns off the server power and then turns on the power. The -s
option shuts down the operating system before the server is turned off.
Note: The Remote Supervisor Adapter II software must be installed and running
for the -s option to function correctly.
SlimLine.
Chapter 6. Command-line interface
97