Setting Up Pxe Network Boot; Serial Redirection Quick Setup - IBM Remote Supervisor Adapter II User Manual

Setting up PXE network boot

Note: The PXE network boot feature is not available on all servers.
Complete the following steps to set up your server to attempt a Preboot Execution
Environment (PXE) network boot at the next server restart:
1. Log in to the Remote Supervisor Adapter II. For more information, see
2. In the navigation pane, click PXE Network Boot. A page similar to the one in
3. Select the Attempt PXE network boot at next server restart check box.
4. Click Save.

Serial redirection quick setup

Note: This feature is not available on the Remote Supervisor Adapter II SlimLine in
You can use the Remote Supervisor Adapter II Web interface serial redirection
wizard to simplify the configuration of serial redirection.
To use the serial redirection wizard, complete the following steps:
1. Log in to the Remote Supervisor Adapter II. For more information, see
2. In the navigation pane, click Serial Redirect. A page similar to the one in the
86
Remote Supervisor Adapter II SlimLine and Remote Supervisor Adapter II: User's Guide
1) In the Microsoft Windows Control Panel, click Add/Remove Hardware;
then, click Next.
2) Select Uninstall/Unplug a device; then, click Next.
3) Click Unplug/Eject a device; then, click Next.
b. Select USB Mass Storage Device and click Stop.
c. Click Close.
d. In the Remote Control window, click Unmount Drive.
Chapter 2, "Opening and using the Web interface," on page 5.
the following illustration is displayed.
some servers.
Chapter 2, "Opening and using the Web interface," on page 5.
following illustration is displayed.