Setting Remote Alert Attempts - IBM Remote Supervisor Adapter II User Manual

To verify whether the selected Remote Supervisor Adapter II is the gateway to the
interconnect network, complete the following steps:
1. Log in to the Remote Supervisor Adapter II for which you want to see the alert
2. In the navigation pane, click Alerts and scroll down to the Alert Forwarding
3. The Status field shows whether the Remote Supervisor Adapter II is the

Setting remote alert attempts

Note: For the Remote Supervisor Adapter II SlimLine, the configuring remote alert
The remote alert attempts settings apply only to forwarded alerts.
Complete the following steps to set the number of times that the Remote Supervisor
Adapter II attempts to send an alert:
1. Log in to the Remote Supervisor Adapter II on which you want to set remote
2. In the navigation pane, click Alerts and scroll down to the Global Remote Alert
26
Remote Supervisor Adapter II SlimLine and Remote Supervisor Adapter II: User's Guide
forwarding status. For more information, see Chapter 2, "Opening and using the
Web interface," on page 5.
area.
gateway and, if it is, whether it is a user-configured or negotiated gateway. The
following values are possible:
v Not a gateway for ISMPs
v User configured gateway for ISMPs
v Negotiated gateway for ISMPs
attempts feature is available only when using LAN-based alert functionality.
alert attempts. For more information, see Chapter 2, "Opening and using the
Web interface," on page 5.
Settings area.
Use these settings to define the number of remote alert attempts and the length
of time between the attempts. The settings apply to all configured remote alert
recipients.