Chapter 10 A/D Converter; A/D Converter Functions; A/D Converter Configuration - NEC PD78081(A) User Manual

10.1 A/D Converter Functions

The A/D converter converts an analog input into a digital value. It consists of 8 channels (ANI0 to ANI7) with an
8-bit resolution.
The conversion method is based on successive approximation and the conversion result is held in the 8-bit A/D
conversion result register (ADCR).
The following two ways are available to start A/D conversion.
(1) Hardware start
Conversion is started by trigger input (INTP3).
(2) Software start
Conversion is started by setting the A/D converter mode register.
Select 1 channel of analog input from ANI0 to ANI7 and perform A/D conversion. As for A/D conversion operations,
when the hardware is started up, the A/D conversion operation stops when A/D conversion is completed, and an
interrupt request (INTAD) is generated. In the case of software start, the A/D conversion operation is repeated. Each
time an A/D conversion operation ends, an interrupt request (INTAD) is generated.

10.2 A/D Converter Configuration

The A/D converter consists of the following hardware.
Analog input
Control register
Register

CHAPTER 10 A/D CONVERTER

CHAPTER 10 A/D CONVERTER
Table 10-1. A/D Converter Configuration
Item
8 Channels (ANI0 to ANI7)
A/D converter mode register (ADM)
A/D converter input select register (ADIS)
External interrupt mode register 1 (INTM1)
Successive approximation register (SAR)
A/D conversion result register (ADCR)
Configuration
119