Swashplate Assembly - JR Vigor CS Assembly Instructions Manual

4-1

SWASHPLATE ASSEMBLY

.....................................1 pc
Set Screw, 3 x 3 mm
.............................4 pcs
Flat Head Screw, 2 x 10 mm
.................................4 pcs
Steel Joint Ball
....................................4 pcs
Joint Ball Spacer, 2.75 mm
..........................3 pcs
Control Ball, 4 mm
Control Ball, 20 mm (140 CCPM)
Use Red Threadlock
on all screws
140 CCPM Swash Type
If there is play between the upper and lower swashplate,
tighten set screw 3 x 3 mm to the lower of swashplate
little by little.
*CAUTION : Do not tighten too much.
Joint Ball Spacer, 2.75 mm (4 pcs)
(note correct direction)
140/120 Aluminum
Swashplate Assembly
...2 pcs
Short Control Ball,
4 mm (1 pc)
Long Control Ball, 20 mm (2 pcs)
Note:
Steel Joint Ball (4 pcs)
120 CCPM Swash Type
25
Flat Head Screw,
Steel
2 x 10 mm (4 pcs)
Joint Ball
Joint Ball
Spacer, 2.75 mm
Short Control Ball,
4 mm (3 pcs)
Set Screw, 3 x 3 mm (3 pcs)