Servo/Switch Harness Installation - JR Vigor CS Assembly Instructions Manual

6-2
................20 pcs
Self Tapping Screw, 2.6 x 12 mm
.............2 pcs
Self Tapping Screw, 2.6 x 15 mm
...............................20 pcs
Flat Washer, 2.6 mm
...........................8 pcs
CA Stopper Ring, 3.5 mm
.......................4 pcs
Type-B Servo Mounting Plate
*
Note correct servo
output shaft orientation
during installation.
CA Stopper Ring, 3.5 mm
Attach as shown.
Flat Washer, 2.6 mm (8 pcs)
Self Tapping
Screw, 2.6 x 12 mm (8 pcs)
Dampener Rubber
(2 pcs)
Switch
Switch Plate

SERVO/SWITCH HARNESS INSTALLATION

Type-B Servo
Mounting Plate (2 pcs)
Self Tapping Screw, 2.6 x 15 mm (2 pcs)
*This portion only. (without washer)
Aileron Servo
(Ch2)
B Collective Servo
(Ch6)
Type-B Servo
Mounting Plate
Rudder
Servo
Elevator Servo
A
(Ch3)
Flat Washer, 2.6 mm (10 pcs)
Self Tapping Screw, 2.6 x 12 mm (10 pcs)
Throttle
Servo
Switch Harness
Off
On
Switch Dampener
Rubber (2 pcs)
38
*
Note output
shaft direction.
A
B
TEAM TIP: When installing the
switch harness, position it so
that "Up" is off and "Down" is the
on position. This will prevent the
switch from accidentally being
turned off in a hard landing
or auto.
Screws Supplied
with Switch