Receiving And Transmitting - Icom IC-M35 Instruction Manual

4
BASIC OPERATION

■ Receiving and transmitting

CAUTION: Transmttng wthout an antenna may damage
the transcever.
q Push and hold [
w Set the volume and squelch levels.
You can enter each adjust mode wth [VOL/SQL MONI].
➥ Enter the squelch adjustment mode, and push [Z] sev-
eral tmes to open the squelch.
➥ Enter the volume adjustment mode, then push [Y]/[Z]
to adjust the volume level.
➥ Enter the squelch adjustment mode agan, and push
[Y] untl the nose dsappears.
e Push [Y]/[Z] to select the desred channel.
• When recevng a sgnal, "
from the speaker.
• Further adjustment of the audo may be necessary at ths pont.
r Push [Hi/Lo ] to select the output power f necessary.
• "LOW" appears when low power s selected; no ndcaton when
hgh power s selected.
• Choose low power for short range communcatons, choose
hgh power for longer dstance communcatons.
• Some channels are for low power only.
t P ush and hold [PTT] to transmt, then speak nto the
mcrophone.
• " " appears.
• Channel 70 cannot be used for transmsson.
y Release [PTT] to receve.
10
] to turn power ON.
" appears and audo s emtted
IMPORTANT: To maxmze the readablty of your trans-
mtted sgnal, pause a few sec. after pushng [PTT], hold
the mcrophone 5 to 10 cm from your mouth and speak
nto the mcrophone at a normal voce level.
NOTE: The transcever has a power save functon to con-
serve the battery power. The power save functon act-
vates automatcally when no sgnal s receved for 5 sec.
t Push to
transmit.
y Release to
receive.
Enter the volume
w
and squelch ad-
justment mode.
Microphone
w Adjust the
volume and
squelch level.
e Set channel.
r Set output
power.
q Power ON.