IBM System storage DS6000 Series Redbook page 399

The creation wizard then displays the "Select target LSS" panel; see Figure 26-10. Here you
select from the pull-down lists the Storage complex , then the Storage unit , then the
Storage Image and finally the LSS , which contains the corresponding target volumes of the
Global Copy pairs. Click Next to proceed with the third step of this wizard.
Figure 26-10 Global Copy paths creation step 2 - select the target LSS
Then the creation wizard displays the "Select source I/O ports" panel; see Figure 26-11. Here
you select, with the check boxes, the I/O ports through which you intend to connect the
source LSS to the target LSS. In the location column, four digits indicate the location of a port:
The first digit - R - is to locate the frame.
The second digit - E - is for the I/O enclosure.
The third digit - C - is for the adapter.
The fourth digit - P - is for the adapter port.
Figure 26-11 Global Copy paths creation step 3 - select the source I/O ports
Click Next to proceed with the fourth step of this wizard.
Chapter 26. Global Mirror examples
375