Cisco 7962G Administration Manual page 102

Security Configuration Menu
Table 4-18 802.1X Authentication Settings
Option Description
Device Determines whether 802.1X
Authentication authentication is enabled:
•
•
EAP-MD5 Specifies a password for use with
802.1X Authentication using the
following menu options (described in
the following rows):
•
•
•
Device ID—A derivative of the
phone's model number and unique
MAC address displayed in this
format: CP-<model>-SEP-<MAC>
Shared Secret—Choose a password
to use on the phone and on the
authentication server. The password
must be between 6 and 32 characters,
consisting of any combination of
numbers or letters.
Note
Realm—Indicates the user network
domain, always set as Network.
Cisco Unified IP Phone 7962G and 7942G Administration Guide for Cisco Unified Communications Manager 6.0
4-34
Enabled—Phone uses 802.1X
authentication to request
network access.
Disabled—Default setting in
which the phone uses CDP to
acquire VLAN and network
access.
Device ID
Shared Secret
Realm
If you disable 802.1X
authentication or perform a
factory reset of the phone, the
shared secret is deleted.
Chapter 4 Configuring Settings on the Cisco Unified IP Phone
To Change
1. Choose Settings > Security
Configuration > 802.1X
Authentication > Device
Authentication.
Set the Device Authentication
2.
option to Enabled or Disabled.
Press the Save softkey.
3.
Choose Settings > Security
Configuration > 802.1X
Authentication > EAP-MD5.
Display only—Cannot configure.
Choose EAP-MD5 > Shared
1.
Secret.
Enter the shared secret.
2.
Press Save.
3.
See the "Troubleshooting Cisco
Unified IP Phone Security" section on
page 9-9 for assistance in recovering
from a deleted shared secret.
Display only—Cannot configure.
OL-12641-01