Transmission Gear Oil - KYMCO Vitality 50 Owner's Manual

(6) TRANSMISSION GEAR OIL

2-STROKE:
Transmission oil measurement:
1.Place the scooter on its main stand on level ground.
After the engine stops for 2 3 minutes.
2. Remove the oil filler bolt (1) and check the oil level (2).
It should be up to the brim of the hole. If the level is
low, add oil to raise it to the proper level.
3.After refilling, securely tighten the bolt (1).
Recommended Gear Oil: SAE #90
Capacity / Exchanging Capacity: 0.12L / 0.11 L
Transmission oil replacement
1. Place the scooter on a level place.
2. Place a container under the engine.
3. Remove the oil filler bolt (1) and drain plug (3) to
drain the oil.
4. Reinstall the drain plug and tighten it.
5. Fill the engine with oil and install the oil filler bolt.
6. Start the engine and warm up for a few minutes.
While warming up, check for oil leakage. If oil leakage
is found, stop the engine immediately and check
for the cause.
(2) (2)
(3)
CAUTION:
Add gear oil through the oil check
bolt hole (2).
After refilling, use a rag to wipe
clean.
Excess or insufficient gear oil will
affect the engine performance.
Never use gear oil of different
brand or inferior quality which
may result in engine breakdown.
Change gear oil at first 300km and
then change at every 4000km. Add
specified gear oil whenever it is
necessary.
(1)