Download  Print this page

Transmission Gear Oil - KYMCO PEOPLE S 50 Owner's Manual

Hide thumbs


Check the transmission gear oil tank for leakage.
1. Place the scooter on it
Proceed with the following steps aft
been shut off for 2 – 3 minutes.
2. Remove the oil filter bolt (1) and check the oil level (2).
It should be up to the brim of th
low, add oil to raise it to the proper level.
3. After refilling, securely tighten the c
Recommended Gear Oil: S
hange Capacit
0.12/0.09L (50cc)
0.21/0.18L (125/200cc)
Tra m ssion Oil Replacement
ns i
1. Pla
ce the scooter on level ground and
u der the engine.
2. Rem
ve the oil filter b
3. Rei
nstall the drain plug and tighten.
4. Fill th
e engine with oil and install the oil filter bolt.
5. Start the engine, warm it
for l
oi leakage. If oil leakage is found, stop the engine
mediately and look for the cause.
s main stand on level grou
er the engine has
e hole. If the level is
heck bolt.
put a container
olt (1) and drain plug (3) to drain
up for a few minutes and check
Add gear oil through the oil check bolt hole (2).
After refilling, use a rag to wipe clean.
Not enough or too much gear oil will affect
engine performance.
Never use a different brand or inferior
quality gear oil. Engine breakdown may
Change the gear oil at the first 300km and
then change again at every 4000km. Add
specified gear oil whenever necessary.
- 49 -


Table of Contents

   Also See for KYMCO PEOPLE S 50

This manual is also suitable for:

People s 125People s 200People s 50

Comments to this Manuals

Symbols: 0
Latest comments: