Engine Oil Change (4-Stroke) - KYMCO Vitality 50 Owner's Manual

(5) ENGINE OIL CHANGE (4-Stroke)

1.Place the scooter on its center stand on level ground.
2.Remove the oil filler cap/dipstick (1).
3.Remove the drain bolt (2) to drain the oil.
4. Install the drain bolt and tighten it. (Torque: 30 Nm)
5.Refill fresh engine oil for 0.7 liter. Firmly tighten the oil
dipstick.
6.Warm up the engine and check the oil level again after
the engine is stopped for 20 30 seconds.
Specified Oil: SAE10W40
Capacity/Exchanging Capacity:0.85L/0.7L
CAUTION:
When changing the engine oil, also clean the oil
strainer and reinstall it.
Use the specified engine oil.
Change engine oil at first 300km and then change it
at every 2000km.
Engine oil will deteriorate easily and require more
frequent change if the scooter is often ridden in
dusty and cold areas or ridden for short distance.
Do not mix engine oil of different classes or
viscosities. It may cause damage to engine.
(1)
(2)