Cable Preparation (Connector Type) - Omron CQM1 Operation Manual

Wiring and Connections

2-5-6 Cable Preparation (Connector Type)

Recommended Connectors
(Cable Side)
Recommended Wire
Wiring and Assembly
The following circuit reduces the surge current by employing a current-limiting
resistor.
R
OUT L
COM
Prepare the cable for connector-type I/O Units as explained below.
Connector type
Soldered
Crimp
Pressure welded
A soldered-type socket and connector cover are provided with each I/O Unit.
Use AWG26 to 24 (0.2 to 0.13 mm
pins.
Note For details on pin arrangement and the internal circuitry of connectors at the
CQM1 side, refer to the sections on DC Input Units (32 points) and Transistor
Output Units (32 points) in this manual.
The following illustrations show the procedure for wiring and assembly of solder-
type connectors. First pass the electrical wires through heat-contraction tubes
and solder them to the socket pins.
After soldering all of the necessary pins, slide the heat-contraction tubes over
the soldered areas of the respective wires. Then shrink the tubes by heating
them with a jet of hot air.
+
Model (by Fujitsu)
Socket: FCN-361J040-AU
Connector cover: FCN-360C040-J2
Housing: FCN-363J040
Contact: FCN-363J-AU
Connector cover: FCN-360C040-J2
FCN-367J040-AU/F
2
) wire for connecting to all of the connector
Heat-contraction tube
Electrical wire
Connector
Heat-contraction tube
Section 2-5
Set (from OMRON)
C500-CE404
C500-CE405
C500-CE403
35