Table of Contents
Advertisement
NETWORK VARIABLES
6.3.3
Object status (network output SNVT_obj_status nvoStatus)
You can indicate the condition of the node.
Member Name
object_id
The setting value of object request (nviRequest) written to object_id is displayed.
Changes to "1" if an illegal object ID is specified in object_id of the object request
invalid_id
(nviRequest),
invalid_request
Changes to "1" if object_request not supported by the object request (nviRequest) is set.
disabled
Changes to "1" if the object of the inverter is invalid.
out_of_limits
open_circuit
out_of_service
Mechanical_fault
feedback_failure
over_range
under_range
Not supported
electrical_fault
unable_to_measure
comm_failure
fail_self_test
self_test_in_progress
locked_out
Changes to "1" if the operation mode of the inverter is other than the network operation
manual_control
mode.
in_alarm
Changes to "1" during the inverter is in the alarm status.
Changes to "1" if the operation mode of the inverter is network operation mode and run
in_override
command and speed command are not given via the network.
report_mask
programming_mode
Not supported
programming_fail
alarm_notify_disabled
*1
"0" is always set in the unsupported functions bit position.
38
Description
*1
*1
Initial Value
H0
Advertisement
Table of Contents
