HYOSUNG RX 125 Service Manual page 80

● Tighten the magneto rotor nut to the specified
torque.
Thread Lock "1324"
Rotor holder : 09930-40113
Rotor holder : 09930-44511
Magneto rotor nut : 56~60 N∙m (5.6~6.0 kg∙m)
STARTER IDLE GEAR AND MOTOR
● Install the starter idle gear.
● Install the starter motor.
DRIVESHAFT OIL SEAL
AND ENGINE SPROCKET
CAUTION
� Always replace the driveshaft oil seal with a
new one every disassembly to prevent oil
leakage. Also grease the oil seal lip.
On installation, refer to Fig, for correct posi-
tion and direction.
� Replace "O" ring with a new one every disassembly.
CAUTION
After reassembling the LOWER END COMPO-
NENTS, install the O-ring and spacer.
Oil seal
O-ring
ENGINE 3-50