HYOSUNG RX 125 Service Manual page 59

3-29 ENGINE
● Remove the clutch spring mounting bolts diago-
nally while holding the primary driven gear, and
remove the clutch pressure plate.
● After removal of clutch drive and driven plates,
flatten the lock washer and remove the clutch
sleeve hub by using the special tool.
Clutch sleeve hub holder : 09920-53710
● Take off the sleeve hub with the primary driven
gear ass' y
This time well deposite the washer behind the hub.
OIL PUMP DRIVE GEAR, DRIVEN
GEAR AND PRIMARY DRIVE GEAR
● Flatten the lock washer, then remove the nut,
lock washer and oil pump drive gear.
Conrod holder : 09910-20116
CAUTION
This is a left-hand thread nut.
● Remove the oil pump driven gear, then remove
the primary drive gear and key.