HYOSUNG RX 125 Service Manual page 136

BEARING
● When press the bearing, use the special tool.
STEERING STEM NUT
● Tighten the steering stem nut with the special tool.
Clamp wrench : 09940-10122
steering stem nut : 40~50 N∙m (4.0~5.0kg∙m)
● Turn the steering stem right and left, lock-to-
lock, five or six times.
● Tighten the steering stem head bolt to the spec-
ified torque.
Steering stem head bolt : 80~100 N∙m
CAUTION
After performing the adjustment and installing
the steering stem upper bracket, "rock"the front
wheel assembly forward and backward to ensure
that there is no play and that the procedure was
accomplished correctly. If play is noticeable,
re-adjust the steering stem nut.
HANDLEBARS
● Set the handlebars to match its punched mark to
the mating face of the holder.
● Secure the each handlebar clamp in such a way
that the clearances ahead of and behind the
handlebars should be equalized.
Handlebars : 18~28 N∙m (1.8~2.8 kg∙m)
(8.0~10.0 kg∙m)
CHASSIS 6-24