HYOSUNG RX 125 Service Manual page 77

3-47 ENGINE
● Install the clutch camshaft by positioning the
face to right side.
● Install the oill seal by using the 17 mm socket.
● Tighten the oil seal retainer screw.
Assemble the clutch, in the reverse order of disas-
sembly. Pay attention to the following points.
● When inserting the spacer on the countershaft,
apply a small quantity of engine oil to both
inside and outside of the spacer.
● Tighten clutch sleeve hub nut using the special
tool to the specified torque.
Clutch sleeve hub holder : 09920-53710
Clutch sleeve hub nut : 30~50 N∙m (3.0~5.0 kg∙m)
● Be sure to lock the nut by firmly bending the
tongue of the washer.
● Install the drive plates and driven plates to the
sleeve hub.
● Insert push rod in the countshaft.
Cam side
←
Longer
Push piece side
→
Shorter