Installing The Nxd Into A Flat Surface Using #4 Screws - AMX Modero NXD/NXT-1200VG Operation/Reference Manual

Installing the NXD into a Flat Surface using #4 screws

Mounting screws (#4, not included) are secured through circular holes located at the left and right sides of the
NXD panel. The most important thing to remember when mounting the NXD is that the outer frame
(Mounting Tabs) must be installed flush against the mounting surface.

1.
Prepare the area by removing any screws or nails from the surface before beginning the cutout process.
2.
Cut out the surface for the 12-inch Wall Mount using the dimensions shown in FIG. 43 and for the 15-
inch Wall Mount using the dimensions shown in FIG. 44.
FIG. 43 NXD 12-inch Wall Mount panel dimensions using #4 mounting screws
3.
Remove the magnetic faceplate/bezel (A in FIG. 45) from the main NXD unit (B in FIG. 45) by gripping
the faceplate and pulling with gentle outward force.
VG-Series Modero Touch Panels
It is recommended that you cutout the surface slightly smaller than what is outlined in the
installation drawings so that you can make any necessary cutout adjustments.
THESE 4 HOLES ARE ONLY REQUIRED
WHEN MOUNTING UNIT TO A SOLID
SURFACE (PODIUM, DESK, ETC.).
SECURE UNIT WITH #4 SCREWS.
Installation Procedures: 12" and 15" Panels
CUTOUT
FRONT BEZEL
55