Table of Contents
Advertisement
You can operate JVC's audio and video components with this unit's remote control, since control signals for JVC.\ components are preset in the
remote control.
To operate JVC's audio components using this remote control
l
Aim the remote control directly at the remote sensor on the unit.
l
To operate a source with the remote control, the source must be
selected using the source selecting buttons on the remote control
l
Refer also to the manuals supplied with your components.
n
Sound
control
section
(Amplifier)
After pressing CONTROL repeatedly to show "SOUND" on the
operation mode display. you can perform the following operation\:
SURR ON/OFF
SURR MODE
TEST
CENTER + or -
REAR*L
+ or -
REAR-R + or -
: Turns on or off the Surround modes-
Dolby Digital. DTS Digital Surround. and
Dolby Pro Logic 11.
: Selects the Surround modes.
: Turns on or off the test tone output.
: Adjusts the center speaker channel output
level.
: Adjusts the left rear speaker channel
output level.
: Adjusts the right rear speaker channel
output level.
SUBWOOFER
+ or - : Adjust< \ubwoofer channel output level.
EFFECT
: Selects the effect level.
Note:
l
After
adjusting
sounds, press the source selecting button to operate
your target source by using number buttons; otherwise,
number
buttons cannot be used for operating your
target source.
n
CD recorder
After pressing CDR, you can perform the following operationson a CD
player and a CD recorder:
ci
c
cim
c-"3
Gc
a2
GQ
0
b
: Starts playing.
I44
: Returns to the heginnIng 01 the current
(or
previous)
track.
))I
: Skips to the beginning or the next track.
H
: Stops playing.
II
: Pauses playing. To relea\c it. press W.
1 - 10, +lO : Selects a track number directly.
For track number 5. press 5.
For track number 15. press +lO, then 5.
For track number 20. pres\ +lO, then IO.
For track number 30. prc>\ +10. +lO. then IO.
Note:
* When you start recording
on the CD recorder, use the buttons on
the CD recorder itself or on the remote control supplied
with it.
n
Tuner
You can always perfot-m the following opcrationa:
FM/AM
: Tune\ into the la\t ~lectetl FM or AM station.
0 Each time you press the button. the hand changes between FM and
AM alternately.
After pressing FM/AM. you can perform the following operations on
a tuner:
I - 10, +I0
: Select\ a pre~r channel numhct- directly.
For channel number 5. pre\b 5.
t-or channel nunlher IX. press +lO, then 5.
For channel number 20. pres\ +lO. then IO.
TUNING
0 or 0
: Tune5 into \taliotl\.
FM MODE
: Chanfc\ the FM reception mode
61
Advertisement
Table of Contents
