Table of Contents
Advertisement
n
To tune
in a preset
station
On the front panel:
1 Press FM/AM to select the band.
/ I.3 m
The last received station of the selected band is
tuned in.
F
The CONTROL button\ now work for tuner
operations.
Ex. : When selecting the FM band
2 Press CONTROL
v (or A)
repeatedly until "< PRESET >"
appears on the display.
3 While "< PRESET 9' still remains
on the display, press CONTROL
)
@ 'ONTRoL
@
(or 4) to select a preset channel
number you want.
* PI-essing (or holding) ('ONTROL
) increases the preset
channel number-s.
l
Pressing (or holding) CONTROL 4 decreases the preset
channel numbers.
From the remote control:
1 Press FM/AM.
"TUNER" appears on the
operation mode display.
The last received station of the selected band is tuned in
The number huttona now work for tuner operations.
2
Press the number buttons to select a preset channel number.
l
For channel number 5, press 5.
l
For channel number IS. pt-ess + IO then 5.
l
For channel number 10, press + IO. +lO. then IO.
When an FM itcreo broadcast is hard to receive or noisy, you can
change the FM reception mode while receiving an FM broadcast.
l
You can store the FM reception mode for each preset station.
Before you start, remember...
There is a time limit in doing the following steps.
II' the setting is canceled before you finish, start from step 1 again.
On the front Danel:
7 While listening to an FM station,
press CONTROL
V (or A)
repeatedly until "c FM MODE 9'
appears on the display.
2 While "< FM MODE 9' still remains
on the display, press CONTROL
)
@ 'ONTRoL
@
(or 4) to select "MONO."
l
Each time you press the button, the FM
reception mode alternates between "AUTO
MUTING""
and "MONO."
ANALOG
q
CiI . ..* :spn ..:.. . . . .
:* ,: '"p "!FF? y yy
. . . .
: . . : ; : i
1:: i
:
:...: : : : :
: :.. : I . . .
"wg
: : . . . .
.
..:
: i :*..i i
.im ; *: : : . . . . MA 2 '...;
.
: A
____________ ~-----
.-
PTO
MUTING]o[MONO
:. "AUTO MUTING"
is the initial setting. If you have already
changed the setting, "MONO"
will be shown.
AUTO MUTING : Normally select this.
When a program is broadcasted in stereo,
you will hear stereo sound; when in
monaural, you will hear monaural sounds.
This mode is also useful to suppress static
noise between stations. The AUTO
MUTING indicator lights up on the display.
MONO
: Select this to improve the reception (but
stereo effect will be lost).
In this mode. you will hear noise while
tuning into the stations. The AUTO
MUTING indicator goes off from the
display. (The STEREO indicator also goes
off.)
To restore the stereo effect
Repeat step 1. then select "AUTO MUTING"
in step 2.
From the remote control:
I
Press FM/AM to select an FM station.
Number buttons now work for tuner operations.
2
Press FM MODE.
* Each time you press the button, the FM reception mode
alternates between 'AUTO MUTING"
and "MONO."
18
Advertisement
Table of Contents
