Table of Contents
Advertisement
To move the zoomed-in position
pre\s cur\or rlrl,lr.
To return to normal playback
Press ENTER.
Note:
l
While being zoomed in. the picture may look coarse
II Changing
the VFP setting-VFP
The VFP (Video Fine Procca\or)
f~~nction
enables
you
to
adjust the picture ba\ed on the piclurc tone, or personal preference.
l
There is a time limit in doing the following steps. If the setting is
canceled before you finl\h. start from \tep 1 again.
l
Before using the remote control, press DVD to change the
remote control operation mode.
-
cx3AA
c=xrivJ
q
During playback
OOAO
0
pj$
0
0
7 Press VFP.
The currenl VFP xtrln;
screen appear\ on the TV.
Ex. : When "NORMAL"
is selected
2 Press cursor b (or I) repeatedly to select the
VFP mode.
l
Each time you pre\\ the button. the VFP mode changes as
followr.
NORMAL
: Normally \elcct this.
CINEMA
: Suitable for a movie source.
USER1 and USER2 : You can adjust parameters that affect
the appearance of picture and store the
\cttlnys (\ee the right).
To adiust the aeoearance of the picture
When selecting "USERI"
or "1JSER2," you can adjust the
appearance of picture.
7 Press VFP, then press cursor b (or 4) repeatedly
to select "USERl"
or "USER%."
IV
2 Press cursor v (or A) repeatedly to select a
parameter you want to adjust.
Ad,just gradually to show preferable appearance by confirming
the picture.
GAMMA
: Controls the brightness of neutral tints
while maintaining the brightness of dark
and bright portions (-4 to +4).
BRIGHTNESS
: Controls the brightness of the screen
(-I6 to +l6).
CONTRAST
: Controls the contrast of the screen
(-I6 to +l6).
SATURATION
: Controls the color depth of the screen
(-16 to +16).
TINT
: Controls the tint of the screen
(-16 to +16).
SHARPNESS
: Controls the sharpness of the screen
(+(I 10 +3).
Y DELAY
: Controls the color gap of the screen
(-2 to +2).
3 Press ENTER.
The VFP setting screen disappears and the following pop-up
window appears on the TV.
Ex. : When "GAMMA"
is selected
4 Press cursor v (or A) repeatedly to change the
setting, then press ENTER.
The current VFP setting xreen appears again.
5 Repeat steps 2 to 4 to adjust other parameters.
To turn off the VFP setting screen
Press VFP.
To activate your setting
Press VFP, then press cursor ) (or 4) repeatedly to select
"USER I " or "USER2."
9 The VFP setting screen disappears
if no operations
are done for
more than about IO seconds.
To turn off the VFP setting screen
Press VFP.
40
Advertisement
Table of Contents
