Table of Contents
Advertisement
Basic Operatio
When you have connected digital source components using both the
analog connection and the digital connection methods (see pages 7 to
lo), you can select the input mode.
l
Before selecting the digital input mode, register the digital input
terminal setting correctly (see "Digital input (DIGITAL
IN)
terminals" on page 2 1).
I
2
Press one of the source selecting buttons (DBS,
TV, or CDR) for which you want to change the
input mode.
DE
w
COR
I
4
I
4
8
I
On the front panel
From the remote control
v
Note:
l
You cannot change the input mode when selecting DVD as the
source. Digital input is a/ways used for the built-in DVD player.
Press INPUT ANALOG/DIGITAL
(INPUT ATT.)
on the front panel or ANALOG/DIGITAL
INPUT
on the remote control.
lNP"T
ANALOG
*NALcwDIGITAL
iDlGlTAL
v
INPJT
F
On the front panel
From the remote control
The current input mode appears on the display.
l
Each time you press the button. the input mode alternates
between the analog input ("ANALOG"")
and the digital input
("DGTL AUTO").
ANALOG/DIGITAL AUTO indicator
-L&J
q
q
. . . . i"
. . . :
.'. -.
:
::::
:::
:.A : -.: :...; :
: : : : :
: : i '7
. . . . . . . . . . ,,.:
* "ANALOG"
is the initial setting except for the built-in DVD
player.
DGTL AUTO
: Select this for the digital input mode.
The DIGITAL AUTO indicator lights up.
The unit automatically detects the incoming
signal format, then the sound signal indicator
for the detected signai-~nI)IGTTAL
or dt+
lights up; otherwise, no sound signal indicator\
light UD.
If the following symptoms occur while Dolby Digital or DTS
Digital Surround software is played back. you can change the digital
input mode:
l
Sound does not come out at the beginning of playback.
l
Noise comes out while searching foi- or skipping chapters or
tracks.
On the front panel
Press CONTROL
F (or 4) to select "DGTL D.D."
or "DGTL DTS" while "DGTL AUTO" still remains
on the display.
l
Each time you press the button, the digital input mode changes as
follows:
I*,,
",
-.~
,,,
.-
"-7
DGTLAUTO
M/
DGTi rj.D.
;
TDGy< DTS 1
DGTL AUTO
: Normally select this.
The DIGITAL, AUTO indicator lights up.
The unit automatically detects the incoming
signal format, then the sound signal indicator
for the detected signal lights up.
DGTL D.D.
:
Select this for playing back software encoded
with Dolby Digital.
The ~~DlGlTAL
indicator lights up*.
DGTL DTS
: Select this for playing back software encoded
with DTS Digital Sut-round.
The dt~
indicator lights up".
.'! These indicators flash when no signal or the signal without the
proper format is played back.
When DVD is
selected as
the source, you can also
%btF
change the digital input mode by pressing
ANALOG/DIGITAL
INPUT repeatedly on the remote
control.
Notes:
l
When 'DGTL AUTO"cannot
recognize
the incoming signals, no
sound signal indicators
light up on the display
* When you turn off the unit or select another source, 'DGTL DTS"
and "DGTL D. D." are canceled.
The digital input mode is automatically
reset to 'DGTL AUTO."
ANALOG
: Select this for the analog input mode.
The ANALOG indicator lights up.
13
Advertisement
Table of Contents
