Table of Contents
Advertisement
Warnings,
Cautions
and Others
CAUTION:
TO REDUCE THE RISK OF ELECTRIC
SHOCK,
DO NOT REMOVE COVER (OR BACK).
NO USER SERVICEABLE
PARTS INSIDE.
REFER SERVICING
TO QUALIFIED
SERVICE PERSONNEL.
The lightning
flash with arrowhead
symbol,
within an equilateral
triangle
is intended
to
alert the user to the presence
of uninsulated
"dangerous
voltage"
within
the product's
enclosure
that
may
be
of
sufficient
magnitude
to constitute
a risk of electric
shock to persons.
The exclamation
point within an equilateral
triangle
is intended
to alert the user to the
presence
of
important
operating
and
maintenance
(servicing)
instructions
in the
literature accompanying
the appliance.
WARNING:
TO REDUCE THE RISK OF FIRE
OR ELECTRIC
SHOCK,
DO NOT EXPOSE
THIS APPLIANCE
TO RAIN OR MOISTURE.
For U.S.A.
This equipment has been tested and found to comply wrth the lrmits
for a Class B digrtal device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance
with the
instructions,
may
cause
harmful
interference
to
radio
communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be
determined
by turning the equipment
off and on, the user is
encouraged to try to correct the interference by one or
more
of the
following measures:
Reorient or relocate the recervrng antenna.
Increase
the separation
between
the equipment
and receiver.
Connect the equipment into an outlet on a circuit different from that
to
which the receiver
is connected.
Consult the dealer or an experienced radio/TV technicran for help.
Note to CATV system installer:
This reminder
is provided to call the CATV system installer's
attention to Section 820-40 of the NEC which provides
guidelines
for proper grounding
and, in particular,
specifies that
the cable ground shall be connected
to the grounding
system
of the building, as close to the point of cable entry as practical.
G-l
Advertisement
Table of Contents
