Ceiling Fan Assembly - Emerson MAUI BAY CF2000AB02 Owner's Manual

Maui bay damp location ceiling fan

Hide thumbs Also See for MAUI BAY CF2000AB02:

Owner's manual (12 pages)

Owner's manual (12 pages)

Table Of Contents

Table of Contents

1. Remove the fan motor and housing assembly from

styrofoam packaging and position it so that the top of

the motor is facing you.

2. Separate, untwist and unkink the three motor leads.

Route the motor leads through the hanger

ball/downrod assembly and seat the downrod in the

motor coupling (Figure 1).

WARNING

It is critical that the clevis pin in the motor coupler is

properly installed and the setscrew securely tightened.

Failure to verify that the pin and setscrew are properly

installed (as shown in Figure 2) could result in the fan

falling.

3. Align the clevis pin holes in the downrod with the

holes in the motor coupling. Install the clevis pin and

secure with the hairpin clip (Figure 2). (Pin and clip

are supplied in loose parts bag.) The clevis pin must

go through the holes in the motor coupling and the

holes in the downrod. Push the straight leg of the

hairpin clip through the hole near the end of the

clevis pin until the curved portion of the hairpin clip

snaps around the clevis pin. The hairpin clip must be

properly installed to prevent the clevis pin from

working loose. Pull on the hanger ball to make sure

the clevis pin is properly installed.

4. Install the setscrew (supplied) in the motor

coupling (Figure 2). While pulling up on the hanger

ball, tighten the setscrew using the setscrew wrench

(supplied).

NOTE: The setscrew must be properly installed as

described above, or fan wobble could result.

5.Remove the hanger ball by loosening the setscrew in

the hanger ball until the ball falls freely down the

downrod (Figure 3). Remove the pin from the

downrod, then remove the hanger ball. Retain the pin

and hanger ball for reinstallation in step 8.