1. Restore electrical power to the outlet box by turning
the electricity on at the main fuse box.
2. Check the operation of the fan by gently pulling on
the 4-position speed control pull chain switch. The
operating sequence is as follows:
3. If airflow is desired in opposite direction, turn your
fan off and wait for the blades to stop turning, then
press the rocker switch located on top of the motor
housing, and turn the fan on again. The fan blades
will turn in the opposite direction and reverse
airflow.
Your fan model is equipped with a 4-position,
3-speed pull chain switch. The operating sequence
is as follows:
Three-Speed
1st Pull—HIGH
2nd Pull—Medium
3rd Pull—Low
4th Pull—OFF
To install an accessory light kit, remove the two screws
securing the switch housing cover to the switch
housing. Remove the screw plug from the bottom of the
switch housing cover and install the light kit in
accordance with the light kit Owner's Manual.
IMPORTANT CARE INSTRUCTIONS
for your Ceiling Fan
Periodic cleaning of your new ceiling fan is the only
maintenance that is needed.
When cleaning, use only a soft brush or lint free cloth to
avoid scratching the finish.
Abrasive cleaning agents are not required and should
be avoided to prevent damage to finish.
Using Your Ceiling Fan
Attaching Light Kit
Maintenance
10
REVERSING
SWITCH
Figure 14
WARNING
!
To avoid possible electrical shock, be sure electricity is
turned off at the main fuse box before wiring.
WARNING
!
Do not use water when cleaning your ceiling fan. It
could damage the motor or the blades and create the
possibility of an electrical shock.
SPEED CONTROL
PULL CHAIN SWITCH
U.L. Model No.: CF2000