Strong SRT 7002 User Manual page 18

PART 1 • English
7.3.1.4 scanning by transponder (manual scan)
Press goTo for displaying the transponder list of the highlighted satellite. By pressing goTo again you
switch back to the satellites list.
Single Transponder Scan: Use the pq buttons to highlight the transponder you want to scan. Press
Multi-Transponder Scan: Select the transponders you want to scan with the ok button. The selected
7.3.1.5 satellite Edit options
Add satellites:
Satellite Name:
Edit satellites:
Delete satellite:
7.3.1.6 Transponder Edit options
noTE: Transponders can only be edited when the transponder list is on screen. To do this,
select the satellite you want to edit and press GOTO to open the TP list. The options
below are now available.
Add transponder:
and press bluE for Scan. A window with scanning settings will be displayed.
After configuring the settings like explained in Single Satellite Scan above, press
ok or bluE again to start Multi-Scan on all selected satellites.
bluE for Scan. A window with scanning settings will be displayed. After
configuring the settings (explained in 7.3.1.3 above), press ok or bluE again
to start the scanning of the highlighted transponder. When the scan progress
has been completed, all found channels will be stored and the receiver will
switch to the first found channel.
transponders will be marked with the "ü" symbol. Press bluE for Scan. A
window with scan settings will be displayed. After configuring the settings like
explained in 7.3.1.2 above, press ok or bluE again to start Multi-Scan on all
selected transponders.
Press REd to add a new satellite. In the pop-up banner, enter the satellite's
name and position by using the navigation and numeric buttons.
Press ok to enter text input mode. In the key table select a character by using
the navigation buttons. Press ok to enter the chosen character. When you have
entered the name, navigate to the "OK" button on screen and press ok on the
remote control to confirm the new name. Save the settings with ok or cancel
by EXIT.
Press gREEn to edit the focused satellite. For changing settings see
explanation above. Confirm changes with ok or cancel by EXIT.
Press YElloW to delete the focused satellite. Press ok to confirm deleting or
EXIT to cancel.
Press REd to add a new transponder. In the pop-up banner, enter the
transponder´s data by using the navigation and numeric buttons. Confirm the
settings with ok or cancel with EXIT. An existing TP cannot be stored again
under the same satellite.
15