Strong SRT 7002 User Manual page 17

Move Continue:
Move Step(1):
Store Position:
Goto Reference:
DiSEqC1.3:
Location:
Longitude Direction:
Longitude Angle:
Lattitude Direction:
Latitude Angle:
When all settings have been made, press EXIT to save the data and leave the window.
Now press ok to enter the DiSEqC1.3 menu.
Move Auto will move the dish to the selected satellite automatically.
For Move Continue, Move Step (1) and Goto Reference please see explanation above.
7.3.1.3 Channel scan
Automatic scan
Single Satellite Scan:
Scan Mode:
Default:
Blind Scan:
NetWork:
Crytped:
Service Type:
After configuring, press ok or bluE again to start scanning with the selected settings.
Your receiver will now perform an automatic channel search with the scanning progress shown on
screen. During the channel search you can skip transponders by pressing the mEnu button, or quit the
scan process with EXIT. When the progress has been completed, all found channels will be stored and
the receiver will switch to the first found channel.
Multi-Satellites Scan:
14
press tu for moving West/East. It will keep moving as long as the button is
hold pressed. By pressing once it will move in 1°step.
press tu for moving West/East in 0.3° step.
to store the current motor position for selected satellite.
to go to the reference 0° position.
Select DiSEqC1.3 with the tu buttons. Press gREEn to setup your location
coordinates. A pop-up window will appear, in which the following settings can
be made:
Use tu to select one of the pre-set locations. Choose a location nearest to
you. If you know the coordinates of your place of residence, you can choose
Manual and make the following extra adjustments:
Choose East or West.
Use the numERIC buttons to enter the coordinate.
Choose North or South.
Use the numERIC buttons to enter the coordinate.
Press bluE for Scan. A window with scan settings will be displayed.
Use tu to select Default, Blind Scan or NetWork.
All stored transponders in the memory will be scanned.
Slow scan in 2 MHz steps. The receiver will first scan the whole frequency band
to find the transponders it can lock on. After gathering all transponders, it
scans the transponders one by one to get all available programmes.
Network search will be performed – when network information is broadcasted
new transponders will be found and stored.
Press tu to select All Channels (scrambled and free) or FTA Channels (free to
air);
Press tu to select ALL, DTV or Radio.
When using a multi feed antenna with more than 1 LNB, select the satellites
your antenna is adjusted to with the ok button. The selected satellites will be
marked by the " " symbol. Set the appropriate LNB inputs in the DiSEqC point
ü
PART 1 • English