RAID Configuration
The RAID options available for your system is the Mylex AcceleRAID
board, which gives your system the added security of fault tolerance.
If you order a system with a RAID controller, the system is pre-cabled at the factory
(see "RAID System Cabling Configuration" figures below.)
If you are adding the AcceleRAID
configure the controller. Refer to "Installing a RAID Controller Board" in Chapter 4.
Note that Jumper JP10 (see figure below) that enables the SCSI Interrupt Steering
Logic (SISL) control on the RAID controller must be in its off position (not jumpered),
which is its default position.
configuration. If your system requires a jumper change, change only
the jumper setting for that condition. Otherwise, keep the jumper at
its factory setting.
A-8 System Cabling
Note:
The jumper is set correctly at the factory for your system
AcceleRAID Jumper JP10
™
150 Controller you must install, cable, and
™
150 Controller