NEC TM1200 User Manual page 97

11. Connect the interface and power cables to the device as follows (see Figure above):
12. If you are installing a 5 1/4-inch tape drive or other IDE device, align and connect the
drive signal cable and the system power cable to their connectors. The cable connector
for the 5 1/4-inch device is keyed to fit only in the correct position. The red edge of the
cable goes to pin 1 on the cable connector. Align the red edge of the connector with pin
1 (notched end) on the drive connector.
13. If you are installing a SCSI device, connect the SCSI cable and system power cable. Be
sure to align the SCSI cable connector (keyed) with the device connector.
14. Carefully reinstall the front panel by inserting its right plastic tabs into the chassis right
tab slots and then pushing its left portion straight in against the chassis.
15. Reinstall the side panel, and power on the system.
Installing a Removable Media Device
Upgrading Your System 4-23